Nissan Juke Service and Repair Manual : System description
Precautions for Harness Repair
• Solder the repaired area and wrap tape around the soldered area. NOTE: A fray of twisted lines must be within 110 mm (4.33 in). • Bypass connection is never allowed at the repaired area. N ...Component parts
Component Parts Location LHD MODELS 1. Multi display unit 2. ABS actuator and electric unit (control unit) 3. A/C auto amp. (With auto air conditioning) PTC heater control unit (Diesel engine ...Other materials:
Final drive
Exploded View
1. Differential side bearing outer race
2. Differential side bearing
3. Final drive
: Replace the parts as a set.
Disassembly
1. Remove differential side bearings, using the drift (A) [SST:
ST33052000] and a puller [Commercial service tool].
Assembly
1. Install different ...
Security indicator lamp
Component Function Check
1.CHECK FUNCTION
1. Perform “THEFT IND” in the “ACTIVE TEST” mode of “BCM” using
CONSULT-III.
2. Check security indicator lamp operation.
Is the inspection result normal?
YES >> INSPECTION END
NO >> Go to SEC-227, "Diagnosis Procedure".
Diagn ...
P1650 thermoplunger control unit
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.CHECK THERMOPLUNGER CONTROL UNIT POWER SUPPLY CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect thermoplunger control unit harness connector.
3. Check the voltage between thermoplunger control unit harness connector and
ground.
Is the ...