Precaution

Precautions for Trouble Diagnosis CAUTION: • Never apply 7.0 V or more to the measurement terminal. • Use a tester with open terminal voltage of 7.0 V or less. • Turn the ignition switch OFF and d ...

System

Can communication system CAN COMMUNICATION SYSTEM : System Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex commun ...

Other materials:

P1078 EVT control position sensor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...

Wiring diagram
Engine control system For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, "Connector Information/Explanation of Option Abbreviation". ...

B210C starter control relay
DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B210C is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to PCS-30, "DTC Logic". • When IPDM E/R power supply voltage is low (Approx. 7 - 8 V for about 1 second), the DTC B210C may be detected. DTC ...