Nissan Juke Service and Repair Manual : System description
Service
• Never use electrical test equipment to check SRS circuits unless instructed to in this Service Manual. • Before servicing the SRS, turn ignition switch OFF, disconnect battery negative terminal ...Component parts
Component Parts Location 1. Combination meter Refer to MWI-4, "METER SYSTEM : Component Parts Location". 2. Combination switch (spiral cable) 3. Driver air bag module Crash zone sen ...Other materials:
Basic inspection
Description
NOTE:
Only consult the tests after following the diagnostic procedure chart.
Some specific checks are grouped under the ???tests??? heading and are used as
required in different diagnostic
charts.
Work Procedure (TEST 1: Low Pressure Fuel Supply System Check)
NOTE:
• CAUSE
...
Control cable
Exploded View
1. Control cable
2. Lock plate
3. Transaxle assembly
4. Bracket A
5. Bracket B
6. CVT shift selector assembly
A: Manual lever B: Grommet
: N·m (kg-m, ft-lb)
: N·m (kg-m, in-lb)
Removal and Installation
INSTALLATION
CAUTION:
Always apply the parking brake before perfo ...
S terminal circuit
Description
The starter motor magnetic switch is supplied with power when the ignition
switch is turned to the START position
while the selector lever is in the P or N position for CVT models or the clutch
pedal is depressed for M/T
models.
Diagnosis Procedure
CAUTION:
Perform diagnosis un ...