Nissan Juke Service and Repair Manual : Symptom diagnosis
NISSAN DYNAMIC CONTROL SYSTEM
Symptom Table
Power supply and ground circuit
MULTI DISPLAY UNIT MULTI DISPLAY UNIT : Diagnosis Procedure 1.CHECK FUSES Check if any of the following fuses are blown: Is the check result normal? YES >> GO TO 2. NO >> Replace ...Removal and installation
MULTI DISPLAY UNIT Exploded View REMOVAL Refer to IP-12, "Exploded View". DISASSEMBLY 1. Silencer tape 2. Multi display unit 3. Silencer tape 4. Clip 5. Control finisher Rem ...Other materials:
B2195 anti-scanning
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON.
2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.
Is DTC detected?
YES >> Refer to SEC-206, "Diagnosis Procedure".
NO >&g ...
5TH main gear assembly
Removal and Installation
REMOVAL
1. Shift the shifter lever to the 3rd gear position.
2. Disconnect the shifter cable and the selector cable from shifter lever A and
selector lever. Refer to TM-25,
"Removal and Installation".
CAUTION:
Never move shifter lever A and the selector l ...
P0171 fuel injection system function
DTC Logic
DTC DETECTION LOGIC
With the Air/Fuel Mixture Ratio Self-Learning Control, the actual mixture
ratio can be brought closely to the
theoretical mixture ratio based on the mixture ratio feedback signal from the
A/F sensor 1. The ECM calculates
the necessary compensation to correct the ...