Nissan Juke Service and Repair Manual : Symptom diagnosis
- Push-button ignition switch does not operate
- Push-button ignition switch position indicator does not illuminate
Push-button ignition switch position indicator
Description Push-button ignition switch changes the power supply position. BCM maintains the power supply position status. BCM changes the power supply position with the operation of the push-b ...Push-button ignition switch does not operate
Description Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis, and check each symptom. NOTE: The engine start function, door lock function, p ...Other materials:
B1184 lap Pre-tensioner LH
DTC Logic
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAGNOSTIC RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp status. Refer to SRC ...
Speedometer and odometer
Speedometer
The speedometer indicates vehicle speed in miles per hour (MPH) and kilometers
per hour (km/h).
Odometer/twin trip odometer
The odometer 1 /twin trip odometer 2 are displayed when the ignition switch is
in the ON position.
The odometer records the total distance the vehicle h ...
Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE:
• Before removing and installing any control units, first turn the ignition
switch to the LOCK position, then disconnect
both battery cables.
• After finishing work, confirm that all control unit connectors are connected
properly, then re-connect both
battery cables.
• Always use CONS ...