Nissan Juke Service and Repair Manual : Symptom diagnosis
- Exterior lighting system symptoms
- Both side headlamps (HI) are not turned on
- Both side headlamps (LO) are not turned on
- Parking, license plate and tail lamps are not turned on
- Both side front fog lamps are not turned on
Hazard switch
Component Function Check 1.CHECK HAZARD SWITCH SIGNAL BY CONSULT-III CONSULT-III DATA MONITOR 1. Turn the ignition switch ON. 2. Select “HAZARD SW” of BCM (FLASHER) data monitor item. 3. With ope ...Exterior lighting system symptoms
Without daytime running light system WITHOUT DAYTIME RUNNING LIGHT SYSTEM : Symptom Table CAUTION: Perform the self-diagnosis with CONSULT-III before the symptom diagnosis. Perform the trouble di ...Other materials:
P0706 transmission range sensor A
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition
switch OFF and wait for at
least 10 seconds, then perform the next test.
>> GO TO 2.
2.PERFORM DTC CONFIRMATION ...
Combination switch output circuit
Diagnosis Procedure
1.CHECK OUTPUT 1 - 5 CIRCUIT FOR OPEN
1. Turn ignition switch OFF.
2. Disconnect BCM and combination switch connectors.
3. Check continuity between BCM harness connector and combination switch harness
connector
Does continuity exist?
YES >> GO TO 2.
NO >> ...
Diagnosis and repair workflow
Work Flow
OVERALL SEQUENCE
• Malfunctions are declared as either present or stored (depending on whether
they appeared in a certain context
and have disappeared since, or whether they remain present but have not been
diagnosed within the
current context).
• The present or stored status of ...