Nissan Juke Service and Repair Manual : Symptom diagnosis
NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING
NVH Troubleshooting Chart
Use the chart below to find the cause of the symptom. If necessary, repair or replace these parts.
×: Applicable
Precaution
Service Notice or Precautions for Rear Propeller Shaft • Replace the propeller shaft assembly if there is a breakage or deflection on tube. • Never hit the tube or apply an impact on it during rep ...Periodic maintenance
REAR PROPELLER SHAFT Inspection APPEARANCE AND NOISE • Check the propeller shaft tube surface for dents or cracks. If damaged, replace propeller shaft assembly. • If center bearing is noisy or d ...Other materials:
Evap canister
2WD : Hydraulic Layout
EVAPORATIVE EMISSION LINE DRAWING
1.EVAP canister purge volume control
solenoid valve
2. EVAP canister
3. EAVP line
4. Fuel line
NOTE:
Do not use soapy water or any type of solvent while installing vacuum hose or
purge hoses.
2WD : Removal and Installation
REMOV ...
Component parts
Component Parts Location
1. Light & rain sensor*1
2. Combination switch
3. Combination meter
4. BCM
Refer to BCS-6, "BODY CONTROL
SYSTEM : Component Parts Location".
5. IPDM E/R
Refer to PCS-5, "Component Parts
Location" (with Intelligent Key system)
or PCS-37, ...
Line pressure test
Work Procedure
INSPECTION
1. Check the engine oil level. Replenish if necessary. LU-25, "Inspection".
2. Check for leak of the CVT fluid. Refer to TM-480, "Inspection".
3. Drive for about 10 minutes to warm up the vehicle so that the CVT fluid
temperature is 50 to 80°C (122 ...