Nissan Juke Service and Repair Manual : Sunload sensor
Removal and Installation
REMOVAL
1. Remove switch panel. Refer to IP-13, "Removal and Installation".
2. Disconnect sunload sensor connector, and then remove sunload sensor.
INSTALLATION
Install in the reverse order of removal.
In-vehicle sensor
Removal and Installation REMOVAL 1. Remove instrument lower panel (LH/RH). Refer to IP-13, "Removal and Installation". 2. Remove fixing screw, and then remove in-vehicle sensor from ins ...Intake sensor
Exploded View Refer to HA-43, "Exploded View (Automatic Air Conditioning)". (HR16DE) Refer to HA-97, "Exploded View (Automatic Air Conditioning)". (MR16DDT) Removal and Installa ...Other materials:
High pressure fuel pump
Component Function Check
1.CHECK HIGH PRESSURE FUEL PUMP FUNCTION
With CONSULT-III
1. Start engine.
2. Check “FUEL PRES SEN V” in “DATA MONITOR” mode of “ENGINE” using CONSULT-III.
Without CONSULT-III
1. Start engine.
2. Check the voltage between ECM harness connector terminals as per the ...
Instrument panel assembly
Exploded View
LHD models
1. Front passenger air bag module
2. Instrument panel assembly
3. Instrument side finisher LH
4. Combination meter
5. Cluster lid A
6. Push-button ignition switch
7. Steering column upper cover
8. Steering lock escutcheon
9. Steering column lower cover
10. ...
Car phone or CB radio
When installing a car phone or a CB radio in your vehicle, be sure to observe
the following precautions, otherwise the new equipment may adversely affect the
electronic control modules and electronic control system harness.
WARNING
• A cellular phone should not be used for any purpose wh ...