Nissan Juke Service and Repair Manual : Structure and operation

Sectional View

1. 5th input gear


1. 5th input gear
2. 5th-reverse synchronizer hub assembly 3. Input shaft
4. Mainshaft
5. 5th main gear
6. Mainshaft rear bearing 7. 4th main gear
8. 3rd-4th synchronizer hub assembly 9. 3rd main gear
10. 2nd main gear
11. 1st-2nd synchronizer hub assembly 12. Differential side bearing 13. Final gear
14. Differential
15. 1st main gear
16. Mainshaft front bearing 17. Input shaft front bearing 18. Clutch housing
19. 1st double-cone synchronizer 20. 2nd double-cone synchronizer 21. Input shaft rear bearing

System Description

DOUBLE-CONE SYNCHRONIZER

Double-cone synchronizers are adopted for 1st and 2nd gears to reduce operating force of the shifter lever

1 : Outer baulk ring
2 : 2nd main gear
3 : Synchronizer cone
4 : Inner baulk ring
5 : 1st main gear
6 : 1st-2nd coupling sleeve

REVERSE GEAR NOISE PREVENTION FUNCTION (REVERSE BRAKE)


REVERSE GEAR NOISE PREVENTION FUNCTION (REVERSE BRAKE)

Description
Soon after the clutch is disengaged, the input shaft is still rotating due to inertia. This may cause a gear noise when the gear is shifted to reverse position. The reverse gear noise prevention function stops the rotation of the input shaft and enables smooth gear shifting when the reverse gear is selected.

Operation Principle
1. When the gear is shifted to reverse position, 5th-reverse coupling sleeve (1) slides in the reverse direction. ()
)

5 : 5th input gear

2. Synchronizer levers (2) with support point (A) at 5th-reverse synchronizer hub (3) presses 5th-reverse baulk ring (4). ()
)
3. Friction that is generated at 5-reverse baulk ring presses synchronizer lever on 5th-reverse coupling sleeve. ()
)
4. 5th-reverse coupling sleeve that is pressed by synchronizer lever stops the rotation of input shaft.

DTC/Circuit diagnosis


    Component parts
    Component Parts Location POSITION SWITCH 1 : Position switch ...

    DTC/Circuit diagnosis
    POSITION SWITCH BACK-UP LAMP SWITCH : Component Inspection 1.CHECK BACK-UP LAMP SWITCH 1. Disconnect position switch connector. Refer to TM-24, "Removal and Installation". 2. Check con ...

    Other materials:

    P060A ECM
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.INSPECTION START 1. Turn ignition switch ON. 2. Erase DTC. 3. Turn ignition switch OFF and wait for 20 seconds. 4. Turn ignition switch ON and perform the self-diagnosis. Is the DTC P060A displayed again? YES >> GO TO 2. NO &g ...

    Service Notice
    • When removing or installing various parts, place a cloth or padding onto the vehicle body to prevent scratches. • Handle trim, molding, instruments, grille, etc. carefully during removing or installing. Be careful not to oil or damage them. • Apply sealing compound where necessary when ins ...

    Turbocharger boost control
    Turbocharger boost control : SystemDiagram Turbocharger boost control : System Description INPUT/OUTPUT SIGNAL CHART SYSTEM DESCRIPTION Depending on driving conditions, the ECM performs ON/OFF duty control of the turbocharger boost control solenoid valve and controls the boost by adjustin ...