Nissan Juke Service and Repair Manual : Structure and operation

Sectional View

1. Transfer cover


1. Transfer cover
2. Ring gear shaft
3. Companion flange
4. Drive pinion
5. Ring gear
6. Transfer case

Operation Principle

POWER TRANSFER DIAGRAM

1. Engine


1. Engine
2. Transaxle
3. Transfer
4. Propeller shaft
5. Electric controlled coupling 6. Rear final drive

ELECTRIC CONTROLLED COUPLING

1. The 4WD control module supplies command current to each electric controlled coupling (4WD solenoid).

2. Each of control clutch is engaged by electromagnet and torque is detected in control clutch.

3. The cam operates in response to control clutch torque and applies pressure to main clutch.

4. Each of main clutch transmits torque to right and left rear wheels according to pressing power.

NOTE

:
Change each pressing power according to 4WD mode atatus and cornering conditions

• Transmission torque to the right and left rear wheels is determined


• Transmission torque to the right and left rear wheels is determined according to command current.

System


    Component parts
    Component Parts Location LHD models 1. ABS actuator and electric unit (control unit) Refer to BRC-97, "Component Parts Location". 2. ECM Refer to EC-25, "ENGINE CONTROL SYSTEM ...

    System
    4WD system : System Diagram INPUT/OUTPUT SIGNAL It transmits/receives each signal from the following 4WD control module via CAN communication line. 4WD system : System Description • 4WD mo ...

    Other materials:

    L terminal circuit (open)
    Description The “L” terminal circuit controls the charge warning lamp. The charge warning lamp illuminates when the ignition switch is set to ON or START. When the alternator is providing sufficient voltage with the engine running, the charge warning lamp will go off. If the charge warning la ...

    Steering switch signal A circuit
    Description Transmits the steering switch signal to NAVI control unit. Diagnosis Procedure 1.CHECK STEERING SWITCH SIGNAL A CIRCUIT 1. Disconnect NAVI control unit connector and spiral cable connector. 2. Check continuity between NAVI control unit harness connector and spiral cable harness co ...

    Removal and Installation
    REMOVAL • Disconnect each joint and mounting. • Remove heated oxygen sensor 2 with following procedure: - Using heated oxygen sensor wrench [SST: KV10114400] (A), removal heated oxygen sensor 2 (1). CAUTION: Be careful not to damage heated oxygen sensor 2. INSTALLATION Note the following ...