Nissan Juke Service and Repair Manual : Steering switch
Exploded View
Refer to SR-13, "Exploded View".
Removal and Installation
REMOVAL
Refer to SR-13, "Removal and Installation".
INSTALLATION
Install in the reverse order of removal.
Microphone
Removal and Installation REMOVAL 1. Remove headlining. Refer to INT-26, "Exploded View". 2. Remove microphone connector and pawl to remove microphone. INSTALLATION Install in the reve ...USB connector and aux jack
Removal and Installation REMOVAL 1. Remove cluster tray. Refer to IP-12, "Exploded View". 2. Push the pawl from the back of cluster tray to remove USB connector and AUX jack. INSTALL ...Other materials:
P0137 HO2S2
DTC Logic
DTC DETECTION LOGIC
The heated oxygen sensor 2 has a much longer switching time
between rich and lean than the air fuel ratio (A/F) sensor 1. The oxygen
storage capacity of the three way catalyst (manifold) causes the
longer switching time. To judge the malfunctions of heated oxygen
...
Power supply and ground circuit
A/C auto AMP. : Diagnosis Procedure
1.CHECK SYMPTOM
Check symptom (A or B).
Which symptom is detected?
A >> GO TO 2.
B >> GO TO 5.
2.CHECK FUSE
1. Turn ignition switch OFF.
2. Check 10A fuse (No. 3).
NOTE:
Refer to PG-23, "Fuse and Fusible Link Arrangement".
...
C1140 actuator relay system
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
With CONSULT ...