Nissan Juke Service and Repair Manual : Steering does not lock
Description
Steering does not lock when door is open while ignition switch is OFF.
NOTE
:
Before performing the diagnosis, check “Work Flow”. Refer to SEC-47, "Work
Flow".
Diagnosis Procedure
1.CHECK DOOR SWITCH
Check door switch.
Refer to DLK-87, "Component Function Check" (With super lock) or DLK-258, "Component Function Check" (Without super lock).
Is the inspection normal? YES >> GO TO 2.
NO >> Repair or replace malfunctioning parts.
2.CHECK DETENTION SWITCH
Check CVT shift selector (detention switch). Refer to SEC-83, "Component Inspection".
Is the inspection normal? YES >> GO TO 3.
NO >> Repair or replace malfunctioning parts.
3.CONFIRM THE OPERATION
Confirm the operation again.
Is the inspection normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
NO >> GO TO 1.
Engine does not start when intelligent key is inside of vehicle
Description Engine does not start when push-button ignition switch is pressed while carrying Intelligent Key. NOTE: • Check that vehicle is under the condition shown in “Conditions of vehicle” ...Security indicator lamp does not turn on or blink
Description Security indicator lamp does not blink when ignition switch is in a position other than ON. NOTE: • Before performing the diagnosis, check “Work Flow”. Refer to SEC-47, "Work ...Other materials:
B1136 side air bag module LH
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...
P0078 EVT control solenoid valve
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following procedure
before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition swit ...
C1155 brake fluid level switch
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
With CONSULT ...