Nissan Juke Service and Repair Manual : Steering angle sensor
Removal and Installation
REMOVAL
1. Remove spiral cable assembly. Refer to SR-16, "Removal and Installation".
2. Remove steering angle sensor.
INSTALLATION
Note the following, and install in the reverse order of removal.
• Perform steering angle sensor neutral position adjustment when steering angle sensor is removed and installed, or replaced. Refer to BRC-149, "Work Procedure".
Yaw rate/side/decel G sensor
Exploded View 1. Yaw rate/side/decel G sensor 2. Yaw rate/side/decel G sensor harness connector 3. Bracket : Vehicle front : N·m (kg-m, in-lb) Removal and Installation REMOVAL CAUTION: Ne ...ESP off switch
Removal and Installation REMOVAL 1. Remove lower instrument panel. Refer to IP-13, "Removal and Installation". 2. Remove ESP OFF switch. INSTALLATION Installation is the reverse ord ...Other materials:
Blower fan on signal
Component Function Check
1.CHECK BLOWER FAN ON SIGNAL
With CONSULT-III
1. Turn ignition switch ON.
2. Select “AIR CONDITIONER” of “BCM” using CONSULT-III.
3. Select “FAN ON SIG” in “DATA MONITOR” mode.
4. Check blower fan ON signal when the fan control dial is operated.
Is the inspection re ...
Service data and specifications (SDS)
Wheel Bearing
Drive Shaft
M/T
*: For measuring position, refer to FAX-54, "WHEEL SIDE : Disassembly and
Assembly" (Wheel side), FAX-
56, "TRANSAXLE SIDE : Disassembly and Assembly" (Transaxle side).
CVT
*: For measuring position, refer to FAX-54, "WHEEL SIDE ...
C1140 actuator relay system
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
With CONSULT ...