Nissan Juke Service and Repair Manual : Starter motor drive control

Starter motor drive control : System Diagram

Starter motor drive control : System


Starter motor drive control : System DescriptionINPUT/OUTPUT SIGNAL CHART

INPUT/OUTPUT SIGNAL CHART

*: With Intelligent Key system


*: With Intelligent Key system SYSTEM DESCRIPTION

When rapid deceleration occurs during engine runs or idle speed decreases due to heavy load conditions, ECM detects a decrease in idle speed and restarts the engine to secure reliability in handleability by transmitting a cranking request signal to IPDM E/R for activating the starter motor under the following conditions:
• Selector lever: P or any position other than N • Idle switch: ON (Accelerator pedal not depressed) • Brake switch: ON (Brake pedal depressed)

Models with no Intelligent Key System transmit a control signal directly to IPDM E/R. On the other hand, models with the Intelligent Key System transmit a control signal to IPDM E/R by way of BCM via CAN communication.

IPDM E/R detects an operating state of the starter motor relay and the starter motor control relay and transmits a feed back signal to ECM via CAN Communication.

    Cooling fan control
    Cooling fan control : System Diagram Cooling fan control : System Description INPUT/OUTPUT SIGNAL CHART *: The ECM determines the start signal status by the signals of engine speed and batter ...

    Evaporative emission system
    Evaporative emission system: System Diagram Evaporative emission system : System Description INPUT/OUTPUT SIGNAL CHART *: ECM determines the start signal status by the signals of engine spee ...

    Other materials:

    Precaution
    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver a ...

    Precautions for Drive Shaft
    • Observe the following precautions when disassembling and assembling drive shaft. - Never disassemble joint sub-assembly because it is non-overhaul parts. - Perform work in a location which is as dust-free as possible. - Clean the parts, before disassembling and assembling. - Prevent the entr ...

    NISSAN Vehicle Immobilizer System
    The NISSAN Vehicle Immobilizer System will not allow the engine to start without the use of the registered key. If the engine fails to start using the registered key, it may be due to interference caused by another registered key, an automated toll road device or automated payment device on t ...