Nissan Juke Service and Repair Manual : Stall test

Work Procedure

INSPECTION

1. Check the engine oil level. Replenish if necessary. Refer to LU-25, "Inspection".

2. Check for leak of the CVT fluid. Refer to TM-480, "Inspection".

3. Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temperature is 50 to 80°C (122 to 176°F).

4. Be sure to apply the parking brake and block the tires.

5. Start the engine, depress the brake pedal and put the selector lever to the D position.

6. While depressing the brake pedal, depress the accelerator pedal gradually.

7. Read the stall speed quickly. Then, release your foot from the accelerator pedal quickly.

CAUTION:
Never depress the accelerator pedal for 5 seconds or more during the test.

Stall speed : Refer to TM-512, "Stall Speed".

8. Place the selector lever in the N position.

9. Cool the CVT fluid.

CAUTION:
Run the engine with the idle speed for at least 1 minute.

10. Put the selector lever to the R position and perform Step 6 to Step 9 again.

NARROWING-DOWN MALFUNCTIONING PARTS

O: Within the stall speed standard value


O: Within the stall speed standard value H: Stall speed is higher than the standard value.

L: Stall speed is lower than the standard value.

    CVT fluid
    Replacement CVT fluid : Refer to TM-512, "General Specification". Fluid capacity : Refer to TM-512, "General Specificatio CAUTION: • Use only Genuine NISSAN CVT Fluid NS-2. Using tr ...

    Line pressure test
    Work Procedure INSPECTION 1. Check the engine oil level. Replenish if necessary. LU-25, "Inspection". 2. Check for leak of the CVT fluid. Refer to TM-480, "Inspection". 3. Driv ...

    Other materials:

    G sensor
    Exploded View 1. Bracket 2. G sensor : Vehicle front : N·m (kg-m, ft-lb) : N·m (kg-m, in-lb) Removal and Installation CAUTION: • Never drop or strike G sensor, because it has little tolerance for impact. • Never use a power tool to avoid impact. REMOVAL 1. Disconnect the battery cable ...

    Door mirror defogger does not operate
    Both sides BOTH SIDES : Description Both door mirror defoggers do not operate BOTH SIDES : Diagnosis Procedure 1.CHECK REAR WINDOW DEFOGGER Check rear window defogger. Refer to DEF-31, "Component Function Check". Is the inspection result normal? YES >> GO TO 2. NO > ...

    4WD warning lamp does not turn on
    Description 4WD warning lamp does not turn ON when the ignition switch is turned to ON. Diagnosis Procedure 1.CHECK 4WD WARNING LAMP Perform the trouble diagnosis for 4WD warning lamp. Refer to DLN-80, "Diagnosis Procedure". Is the inspection result normal? YES >> Check eac ...