Nissan Juke Owners Manual : Speaker Adaptation (SA) mode

Speaker Adaptation allows up to two out-of dialect users to train the system to improve recognition accuracy. By repeating a number of commands, the users can create a voice model of their own voice that is stored in the system.

The system is capable of storing a different speaker adaptation model for each connected phone.

Training procedure

1. Position the vehicle in a reasonably quiet outdoor location.

2. Sit in the driver’s seat with the engine running, the parking brake on, and the transmission in Park.

3. Push and hold the than 5 seconds. button for more
than 5 seconds.

4. The system announces: “Push the PHONE SEND () button for the hands-free phone system to enter the speaker adaptation mode or
) button for the hands-free phone system to enter the speaker adaptation mode or push the PHONE END (a different language.” ) button to select
a different language.”
5. Push the on selecting a different language, see “Choosing a language” (P.4- 55). button. For information
on selecting a different language, see “Choosing a language” (P.4- 55).

6. If the connected phone is already in use, the system will prompt you to overwrite. Follow the instructions provided by the system.

7. When preparation is complete and you are ready to begin, push the button.

8. The SA mode will be explained. Follow the instructions provided by the system.

9. When training is finished, the system will tell you an adequate number of phrases have been recorded.

10. The system will announce that speaker adaptation has been completed and the system is ready.

The SA mode will stop if:

•  The button is pushed for more than 5 seconds in SA mode.

• The vehicle is driven during SA mode.

•  The ignition switch is turned to the OFF or LOCK position.

Training phrases

During the SA mode, the system instructs you to say the following phrases.

(The system will prompt you for each phrase.)

• phonebook transfer entry • dial 3 0 4 2 9
• delete call back number • incoming
•  transfer entry
• 8 pause 9 3 2 pause 7
•  delete all entries •  call 7 2 4 0 9
•  phonebook delete entry • next entry
• dial star 2 1 7 0
•  yes
•  no
•  select
• missed
• dial 8 5 6 9 2
• Bluetooth on
•  Outgoing
• call 3 1 9 0 2
•  9 7 pause pause 3 0 8 •  cancel
• call back number
• call star 2 0 9 5
• delete phone
• dial 8 3 0 5 1
•  Record name
•  4 3 pause 2 9 pause 0 • delete redial number
•  phonebook list names • call 8 0 5 4 1
•  correction
•  setup main menu
•  dial 7 4 0 1 8
•  memo pad delete
•  delete
•  dial 9 7 2 6 6
• call 7 6 3 0 1
• go back
• call 5 6 2 8 0
• dial 6 6 4 3 7

    List of voice commands
    When you push and release the button on the steering wheel, you can choose from the commands on the Main Menu. The following pages describe these commands and the commands in each sub-menu. Re ...

    Troubleshooting guide
    The system should respond correctly to all voice commands without difficulty. If problems are encountered, try the following solutions. Where the solutions are listed by number, try each solution i ...

    Other materials:

    Keyfob battery
    Exploded View 1. Upper case 2. Key 3. Switch cover 4. Switch rubber 5. Board surface 6. Battery 7. plate 8. Lower case 9. Screw Removal and Installation REMOVAL 1. Remove screw (9) on the rear of keyfob. 2. Place the key with the lower case (8) facing up. Set a screw-driver wrap ...

    Structure and operation
    Positive Crankcase Ventilation This system returns blow-by gas to the intake manifold. The positive crankcase ventilation (PCV) valve is provided to conduct crankcase blow-by gas to the intake manifold. During partial throttle operation of the engine, the intake manifold sucks the blow ...

    B1135 side air bag module LH
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...