Nissan Juke Owners Manual : Spark plugs
WARNING
Be sure the engine and ignition switch are off and that the parking brake is engaged securely.
CAUTION
Be sure to use the correct socket to remove the spark plugs. An incorrect socket can damage the spark plugs.
REPLACING SPARK PLUGS
If replacement is required, see a NISSAN dealer for servicing.
Iridium platinum-tipped spark plugs It is not necessary to replace the iridium platinum-tipped spark plugs as frequently as the conventional type spark plugs since they will last much longer. Follow the maintenance log shown in the “NISSAN Service and Maintenance Guide”. Do not reuse the iridium platinum- tipped spark plugs by cleaning or regapping.
Always replace spark plugs with recommended or equivalent ones.
Drive belt
1. Alternator 2. Drive belt auto-tensioner 3. Crankshaft pulley 4. Air conditioner compressor 5. Water pump WARNING Be sure the ignition switch is in the OFF or LOCK position before servicing ...Air cleaner
To remove the filter, pull the air duct1 upward to remove it. Pull the tabs 2 , then pull the cover3 upward. The air cleaner filter should not be cleaned and reused. Replace it according to the ...Other materials:
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
driver and front passenger for certain
types of collision. This system includes seat belt switch inputs and dual stage
f ...
Replacing
Replace the wiper blades if they are worn.
Before replacing the wiper blades, the wiper should be in the fully up position
to avoid scratching the engine hood or damaging the wiper arm. To pull up the wiper
arm, see “Windshield wiper and washer switch” .
1. Lift the wiper arm away from the w ...
C1111 ABS motor, motor relay system
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
With CONSULT ...