Nissan Juke Service and Repair Manual : Spark plug
Exploded View
1. Rocker cover protector
2. O-ring
3. PCV valve
4. PCV hose
5. Clamp
6. Rocker cover gasket
7. Rocker cover
8. Clamp
9. PCV hose
10. Oil filler cap
11. Spark plug
12. Ignition coil
A. To air duct assembly B. Tightening must be done following the installation procedure.
Refer to EM-53
C. To intake manifold
: N·m (kg-m, ft-lb)
: N·m (kg-m, in-lb)
: Always replace after every
disassembly.
Removal and Installation
1. Remove engine cover. Refer to EM-25, "Exploded View".
2. Remove air inlet tube assembly. Refer to EM-31, "Exploded View".
3. Remove ignition coil.
4. Remove spark plug with a spark plug wrench (commercial service tool).
a : 14 mm (0.55 in)
CAUTION:
Never drop or shock spark plug.
INSTALLATION
Install in the reverse order of removal.
Inspection
INSPECTION AFTER REMOVAL
Use the standard type spark plug for normal condition.
Spark plug (Standard type) : Refer to EM-129, "Spark Plug".
CAUTION:
• Never drop or shock spark plug.
• Never use a wire brush for cleaning.
• If plug tip is covered with carbon, spark plug cleaner may be used.
Cleaner air pressure : Less than 588 kPa (6 kg/cm2,
85 psi)
Cleaning time : Less than 20 seconds
• Spark plug gap adjustment is not required between replacement intervals.
• Measure spark plug gap. when it exceeds the limit, replace spark plug even if it is with in the specified replacement mileage.
Refer to EM-129, "Spark Plug".
Air cleaner filter
Removal and Installation REMOVAL 1. Remove air duct assembly (duct side) (1). 2. Unhook the tabs (A) of both ends of the air cleaner cover. 3. Remove the air cleaner filter (1) and air cleaner b ...Other materials:
4WD mode indicator lamp (4WD-V)
Component Function Check
1.4WD MODE INDICATOR LAMP OPERATION CHECK
1. Turn the ignition switch ON.
2. Change 4WD mode switch to “4WD-V”.
3. Check that 4WD mode indicator lamp (4WD-V) turns on.
Is the inspection result normal?
YES >> INSPECTION END
NO >> Proceed to diagnosis proc ...
Models with Intelligent Key system
1. Apply the parking brake.
2. Move the shift lever to the P (Park) or N (Neutral) position. (P is recommended.)
The starter is designed not to operate unless the shift lever is in either of the
above positions.
Manual Transmission (MT) models:
Move the shift lever to the N (Neutral) position ...
Back door opener switch
Component Function Check
1.CHECK FUNCTION
1. Select “TRUNK” of “BCM” using CONSULT-III.
2. Select “TRNK OPNR SW” in “DATA MONITOR” mode.
3. Check that the function operates normally according to the following
conditions.
Is the inspection result normal?
YES >> Back door opener switch ...