Nissan Juke Service and Repair Manual : Side turn signal lamp
Exploded View
1. Side turn signal lamp bulb 2. Side turn signal lamp hous
Removal and Installation
CAUTION:
Disconnect battery negative terminal or remove the fuse.
REMOVAL
1. Remove the side turn signal lamp in numerical order shown in
the figure.
2. Rotate the bulb socket counterclockwise and unlock it.
NOTE
:
Support side turn signal lamp harness with tape so that it won't fall
into the front fender.
: Vehicle front (side turn
signal lamp LH)
: Vehicle rear (side turn signal
lamp RH)
INSTALLATION
1. Rotate the bulb socket clockwise and lock it.
2. Fix the pawl-side behind the side turn signal lamp housing first, then push the resin clip-side.
Replacement
CAUTION:
• Disconnect the battery negative terminal or the fuse.
• Never touch the glass of bulb directly by hand. Keep grease and other oily matters away from it.
• Never touch bulb by hand while it is lit or right after being turned off.
• Never leave bulb out of lamp reflector for a long time because dust, moisture smoke, etc. may affect the performance of lamp. When replacing bulb, be sure to replace it with new one
.
SIDE TURN SIGNAL LAMP BULB
1. Remove side turn signal lamp. Refer to EXL-98, "Removal and Installation".
2. Remove bulb from the bulb socket.
Hazard switch
Exploded View 1. Instrument panel assembly 2. Hazard switch : Pawl Removal and Installation REMOVAL 1. Remove Audio unit. Refer to AV-38, "Removal and Installation". 2. Disengage f ...Headlamp aiming switch
Exploded View 1. Headlamp aiming switch 2. Instrument lower panel assembly LH : Pawl Removal and Installation REMOVAL 1. Remove instrment lower panel (LH/RH). Refer to IP-13, "Removal an ...Other materials:
ECU diagnosis information
IPDM E/R
Reference Value
VALUES ON THE DIAGNOSIS TOOL
TERMINAL LAYOUT
PHYSICAL VALUES
*1: MR16DDT engine models
*2: Except MR16DDT engine models
*3: CVT models
*4: M/T models
*5: With daytime running light system
*6: Without daytime running light system
*7: K9K engine mo ...
Compressor dose dot operate
Description
SYMPTOM
Compressor dose not operate.
Diagnosis Procedure
NOTE:
• Perform self-diagnosis with CONSULT-III before performing symptom diagnosis.
If any malfunction result or
DTC is detected, perform the corresponding diagnosis.
• Check that refrigerant is enclosed in cooler cycle n ...
Rear combination lamp
Exploded View
REMOVAL
1. Grommet
2. Grommet
3. Rear combination lamp
: Clip
: N·m (kg-m, in-lb)
DISASSEMBLY
1. Rear combination lamp housing assembly
2. Back-up lamp bulb
3. Harness connector
4. Rear turn signall lamp bulb
5. Stop/tail lamp bulb
Removal and Installation
CAUTIO ...