Nissan Juke Service and Repair Manual : Side oil seal
Removal and Installation
REMOVAL
1. Remove front drive shafts. Refer to FAX-53, "Removal and Installation".
2. Remove differential side oil seals (1) from clutch housing and transaxle case, using an oil seal remover.
CAUTION:
Never damage transaxle case and clutch housing.
INSTALLATION
Note the following, and install in the reverse order of removal.
• Install differential side oil seals (1) to clutch housing and transaxle case, using the drift [Stamping number: B.vi 1666-B] of the drift set [SST: KV32500QAA].
B : Transaxle case side C : Clutch housing side
Dimension “L1” : 5.7 – 6.3 mm (0.224 – 0.248 in) Dimension “L2” : 2.4 – 3.0 mm (0.094 – 0.118 in)
CAUTION:
• Never incline differential side oil seal.
• Never damage clutch housing and transaxle case.
Inspection
INSPECTION AFTER INSTALLATION
Check the oil level and oil leakage. Refer to TM-22, "Inspection".
Position switch
Removal and Installation REMOVAL 1. Drain gear oil. Refer to TM-22, "Draining". 2. Disconnect position switch connector (A). 3. Remove position switch from transaxle case. INSTALLATIO ...Other materials:
Component parts
Component Parts Location
1. Combination meter
Refer to MWI-4, "METER SYSTEM :
Component Parts Location".
2. Combination switch (spiral cable)
3. Driver air bag module
Crash zone sensor
4. Passenger air bag module
5. Seat belt pre-tensioner LH
6. Satellite sensor LH
7. Lap pr ...
B2608 starter relay
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2608 is displayed with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to
BCS-83, "DTC Logic".
• If DTC B2608 is displayed with DTC U1010, first perform the trouble diagnosis
for DTC U1010. Refer to
BCS-84, "D ...
Front seat (4WD)
Exploded View
DRIVER SEAT
LHD models
1. Headrest
2. Headrest holder (locked)
3. Headrest holder (free)
4. Seatback assembly
(with heater seat only)
5. Inner lower cover
6. Seatback trim
(without heater seat only)
7. Seatback pad
(without heater seat only)
8. Seat belt buckle
9. A ...