Nissan Juke Service and Repair Manual : Side air bag module
Exploded View
1. Side air bag module 2. Front seat assembly
: Do not reuse
: N·m (kg-m, in-lb)
Removal and Installation
WARNING:
• Before servicing, turn ignition switch OFF, disconnect battery negative
terminal and wait 3 minutes
or more.
• Always work from the side of air bag module. Never work in front of it.
• Never use the air tools or electric tools for servicing.
REMOVAL
1. Remove front seat assembly.
• 2WD models: Refer to SE-19, "Removal and Installation".
• 4WD models: Refer to SE-27, "Removal and Installation".
2. Remove seatback trim and pad.
• 2WD models: Refer to SE-19, "SEATBACK : Disassembly and Assembly".
• 4WD models: Refer to SE-27, "SEATBACK : Disassembly and Assembly".
3. Remove side air bag module from seatback trim.
CAUTION
:
• Always place the side air bag module with pad side facing
upward.
: Upward
• Never impact the side air bag module.
• Replace the side air bag module if it has been dropped or sustained an impact.
• Never insert any foreign objects (screwdriver, etc.) into the side air bag module.
• Never disassemble the side air bag module.
• Never expose the side air bag module to temperatures exceeding 90 °C (194 °F).
• Never allow oil, grease, detergent, or water to come in contact with the side air bag module.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
• Never use the old fixing nuts after removal, replace with the new nuts.
• Never damage the air bag harness.
• If malfunction is detected by the air bag warning lamp, after repair or replacement of the malfunctioning parts, reset the memory using self-diagnosis or CONSULT-III. Refer to SRC-12, "On Board Diagnosis Function" or SRC-16, "CONSULT-III Function".
• After the work is completed, check that no system malfunction is detected by air bag warning lamp.
Front passenger air bag module
Exploded View 1. Front passenger air bag module 2. Instrument panel assembly : Pawl : Do not reuse : N·m (kg-m, ft-lb) Removal and Installation WARNING: • Before servicing, turn ignition sw ...Side curtain air bag module
Exploded View 1. Side curtain air bag module : Metal clip : N·m (kg-m, ft-lb) Removal and Installation WARNING: • Before servicing, turn ignition switch OFF, disconnect battery negative term ...Other materials:
EGR volume control valve closed position learning
Description
EGR Volume Control Valve Closed Position Learning is an operation to learn
the fully closed position of the
EGR volume control valve by monitoring the EGR volume control valve control
position sensor output signal.
Work Procedure
1.START
1. Turn ignition switch ON.
2. Perform ? ...
Luggage floor trim
Exploded View
2WD models
1. Rear pillar cap RH
2. Luggage side upper finisher RH
3. Luggage side lower finisher RH
4. Luggage floor board
5. Luggage side upper finisher LH
6. Rear pillar cap LH
7. Luggage side lower finisher LH
8. Seat belt hook LH
9. Shock absorber mask LH
10. Lug ...
Door does not lock/unlock with door request switch
All door request switches
ALL DOOR REQUEST SWITCHES : Description
All doors do not lock/unlock using all door request switches.
ALL DOOR REQUEST SWITCHES : Diagnosis Procedure
1.CHECK REMOTE KEYLESS ENTRY FUNCTION
Check remote keyless entry function.
Does door lock/unlock with Intelligent Ke ...