Nissan Juke Service and Repair Manual : Service regeneration
Description
Service Regeneration is performed with CONSULT-III to reduce particulate matter in diesel particulate filter.
Service Regeneration should be performed in the following cases.
• ECM enters fail-safe mode because the amount of particulate matter in diesel particulate filter reaches the specified level.
NOTE
:
When ECM enters fail-safe mode because the amount of particulate matter in
diesel particulate filter
reaches the specified level, check whether or not DTC is stored in ECM. In the
case of DTC stored, perform
the Diagnostic Procedure for the DTC.
• ECM is replaced.
NOTE
:
Based on the signal from sensors ECM measures the amount of particulate matter
in diesel particulate filter
and stores the value in EEPROM (Electrically Erasable Programmable Read Only
Memory). When ECM is
replaced as new one, there is a difference between the actual amount of
particulate matter and the value
stored in new ECM, because the value stored in new ECM is initialized one. In
the case above, ECM cannot
perform regeneration control correctly. So, perform service regeneration to make
the amount of particulate
matter in diesel particulate filter zero.
• Component Inspection for diesel particulate filter is performed.
CAUTION:
To prevent engine racing, check engine oil level before running the forced
service regeneration command.
Work Procedure
1.START
1. Check engine oil level.
2. Start engine and warm it up to normal operating temperature.
3. Turn ignition switch OFF.
4. Turn ignition switch ON.
5. Select ???SERVC REGENERATION??? in ???WORK SUPPORT??? mode with CONSULT-III.
6. Touch ???START??? and wait for approximately 30 minutes.
NOTE
:
• Do not perform any vehicle operation during service regeneration.
7. Wait until ???END??? is displayed.
NOTE
:
• It takes approximately 30 minutes until ???END??? is displayed.
8. Turn ignition switch OFF and wait at least 10 seconds.
9. Check engine oil level.
>> END
Throttle valve closed position learning
Description Throttle Valve Closed Position Learning is an operation to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal. It must be pe ...DPF (diesel particulate filter) data clear
Description Perform ???DIESEL PARTICULATE FILTER DATA CLEAR??? in ???WORK SUPPORT??? mode with CONSULT-III when oxidation catalyst with diesel particulate filter is replaced as new one. Based on ...Other materials:
Operation inspection
Work Procedure
The purpose of the operational check is to check that the individual system
operates normally.
Check condition : Engine running at normal operating temperature.
1.CHECK MEMORY FUNCTION
1. Set temperature to 30°C by operating the temperature control dial.
2. Press OFF switch.
3 ...
P0524 engine oil pressure
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC P0524 is displayed with DTC P0520 or P0075, perform trouble diagnosis for
DTC P0520 or P0075
first. Refer to EC-674, "DTC Logic" or EC-583, "DTC Logic".
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedur ...
DLC branch line circuit
Diagnosis Procedure
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the data link connector for damage,
bend and loose connection
(connector side and harness side).
Is the inspection res ...