Nissan Juke Service and Repair Manual : Service Notice or Precautions for Manual Transaxle

Nissan Juke Service and Repair Manual / Transaxle & transmission 6MT: RS6F94R / Precaution / Service Notice or Precautions for Manual Transaxle

CAUTION:
• Never reuse CSC (Concentric Slave Cylinder). Because CSC slides back to the original position every time when removing transaxle assembly. At this timing, dust on the sliding parts may damage a seal of CSC and may cause clutch fluid leakage. Refer to CL-27, "Removal and Installation".

• Never reuse transaxle gear oil, once it has been drained.

• Check oil level or replace gear oil with vehicle on level surface.

• During removal or installation, keep inside of transaxle clear of dust or dirt.

• Check for the correct installation status prior to removal or disassembly. If matching marks are required, be certain they never interfere with the function of the parts they are applied.

• In principle, tighten bolts or nuts gradually in several steps working diagonally from inside to outside.

If tightening sequence is specified, use it.

• Never damage sliding surfaces and mating surfaces.

    Precaution for Procedure without Cowl Top Cover
    When performing the procedure after removing cowl top cover, cover the lower end of windshield with urethane, etc. ...

    Other materials:

    MDU branch line circuit
    Diagnosis Procedure 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the multi display unit for damage, bend and loose connection (unit side and connector side). Is the inspection result ...

    L terminal circuit (open)
    Description The “L” terminal circuit controls the charge warning lamp. The charge warning lamp illuminates when the ignition switch is set to ON or START. When the alternator is providing sufficient voltage with the engine running, the charge warning lamp will go off. If the charge warning la ...

    4WD warning lamp blinks slowly
    Description 4WD warning lamp blinks at approximately 2 seconds intervals while driving. Diagnosis Procedure 1.CHECK TIRE Check the following. • Tire pressure • Wear condition • Front and rear tire size (There is no difference between front and rear tires.) Is the inspection result normal ...