How to select piston and bearing

Description • The identification grade stamped on each part is the grade for the dimension measured in new condition. This grade cannot apply to reused parts. • For reused or repaired parts, mea ...

General Specification

GENERAL SPECIFICATIONS ( ): Valve timing control “ON” ...

Other materials:

Combination switch
Exploded View 1. Combination switch 2. Combination switch connector Removal and Installation REMOVAL 1. Remove steering column cover. Refer to IP-13, "Removal and Installation". 2. Remove screws. 3. Disconnect the connector. 4. Pull up the combination switch to remove it. I ...

Periodic maintenance
REAR WHEEL HUB Inspection COMPONENT PART Check the mounting conditions (looseness, back lash) of each component and component conditions (wear, damage) are normal. WHEEL HUB ASSEMBLY (BEARING-INTEGRATED TYPE) Check the following items, and replace the part it necessary. • Move wheel hub ...

Hazard function
Component Function Check 1.CHECK FUNCTION 1. Select “MULTI REMOTE ENT” of “BCM” using CONSULT-III. 2. Select “FLASHER” in “ACTIVE TEST” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Hazard warning lam ...