Nissan Juke Service and Repair Manual : Service data and specifications (SDS)
Wheel Bearing
Drive Shaft
*: For measuring position, refer to RAX-21, "FINAL DRIVE SIDE : Disassembly and Assembly".
Rear drive shaft
Exploded View 1. Circular clip 2. Dust shield 3. Housing 4. Snap ring 5. Ball cage/steel ball/inner race assembly 6. Stopper ring 7. Boot band 8. Boot 9. Shaft 10. Joint sub-assembly ...Front Suspension
...Other materials:
B1066, B1071 passenger air bag module
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...
Power generation voltage variable control system operation
inspection
Inspection Procedure
CAUTION:
When performing this inspection, always use a charged battery that has completed
the battery inspection.
(When the charging rate of the battery is low, the response speed of the voltage
change will
become slow. This can cause an incorrect inspection.)
1.CHECK ...
Forward-facing child restraint installation using the seat belts
WARNING
The three-point seat belt with Automatic Locking Retractor (ALR) must be used
when installing a child restraint.
Failure to use the ALR mode will result in the child restraint not being properly
secured. The restraint could tip over or be loose and cause injury to a child in
a sudden ...