Nissan Juke Service and Repair Manual : Service data and specifications (SDS)
Wheel Bearing
Drive Shaft
2WD
*: For measuring position, refer to FAX-26, "WHEEL SIDE : Disassembly and Assembly" (Wheel side), FAX- 29, "TRANSAXLE SIDE : Disassembly and Assembly" (Transaxle side).
4WD
*: For measuring position, refer to FAX-26, "WHEEL SIDE : Disassembly and Assembly" (Wheel side), FAX- 29, "TRANSAXLE SIDE : Disassembly and Assembly" (Transaxle side).
Inspection
INSPECTION AFTER REMOVAL Check the following items, and replace the part if necessary. • Move joint up/down, left/right, and in the axial directions. Check for motion that is not smooth and for ...Other materials:
Shift lock system
Component Function Check
1.CHECK SHIFT LOCK OPERATION (PART 1)
1. Turn ignition switch ON.
2. Shift the selector lever to “P” position.
3. Attempt to shift the selector lever to any other than position with the brake
pedal released.
Can the selector lever be shifted to any other position?
...
On Board Diagnostic (OBD) System of Engine and CVT
The ECM has an on board diagnostic system. It will light up the malfunction
indicator lamp (MIL) to warn the
driver of a malfunction causing emission deterioration.
CAUTION:
• Be sure to turn the ignition switch OFF and disconnect the negative battery
cable before any repair
or inspection ...
How to set SRT code
Description
OUTLINE
In order to set all SRTs, the self-diagnoses as in the “SRT ITEM” table must
have been performed at least
once. Each diagnosis may require actual driving for a long period of time under
various conditions.
SRT ITEM
The table below shows required self-diagnostic items t ...