Unit removal and installation

TRANSMISSION ASSEMBLY Exploded View 1. Transaxle assembly A: : For the tightening torque, refer to TM-508, "Removal and Installation". Removal and Installation REMOVAL WARNING: Neve ...

General Specification

CAUTION: • Use only Genuine NISSAN CVT Fluid NS-2. Never mix with other fluid. • Use only Genuine NISSAN CVT Fluid NS-2. Using transmission fluid other than Genuine NISSAN CVT Fluid NS-2 will da ...

Other materials:

A/C indicator
Diagnosis Procedure 1.CHECK SYMPTOM Check symptom. A/C indicator dose not turn ON>>GO TO 2. A/C indicator dose not turn OFF>>GO TO 6. 2.CHECK FUSE 1. Turn ignition switch OFF. 2. Check 10A fuse (No. 15, located in fuse block (J/B)]. NOTE: Refer to PG-22, "Fuse, Conn ...

Hood
Exploded View 1. Hood assembly 2. Hood bumper rubber 3. Radiator core seal 4. Hood bumper rubber 5. Clamp 6. Hood hinge 7. Grommet 8. Hood support rod : Clip : Pawl : Body grease Hood assembly HOOD ASSEMBLY : Removal and Installation CAUTION: • Operate with two workers, because ...

A/C on signal
Component Function Check 1.CHECK A/C ON SIGNAL With CONSULT-III 1. Turn ignition switch ON. 2. Operate blower motor. 3. Select “AIR CONDITIONER” of “BCM” using CONSULT-III. 4. Select “AIR COND SW” in “DATA MONITOR” mode. 5. Check A/C ON signal when the A/C switch is operated. Is the inspec ...