Nissan Juke Service and Repair Manual : Sensor rotor
Front sensor rotor : Removal and Installatio
REMOVAL
Replace wheel hub as an assembly when replacing because sensor rotor cannot be disassembled.
• MR16DDT: Refer to FAX-11, "Removal and Installation".
• HR16DE: Refer to FAX-43, "Removal and Installation".
• K9K: Refer to FAX-68, "Removal and Installation".
INSTALLATION
Replace wheel hub as an assembly when replacing because sensor rotor cannot be disassembled.
• MR16DDT: Refer to FAX-11, "Removal and Installation".
• HR16DE: Refer to FAX-43, "Removal and Installation".
• K9K: Refer to FAX-68, "Removal and Installation".
Rear sensor rotor : Removal and Installation
REMOVAL
2WD
Replace wheel hub as an assembly when replacing because sensor rotor cannot be disassembled. Refer to RAX-5, "Removal and Installation".
4WD
1. Remove drive shaft. Refer to RAX-17, "Removal and Installation".
2. Remove sensor rotor from drive shaft. Refer to RAX-21, "FINAL DRIVE SIDE : Disassembly and Assembly".
INSTALLATION
Note the following, and install in the reverse order of the removal.
• Never reuse sensor rotor. (4WD)
Wheel sensor
Front wheel sensor : Exploded View 1. Front LH wheel sensor 2. Front LH wheel sensor harness connector : Vehicle front : N·m (kg-m, in-lb) NOTE: Front RH wheel sensor is symmetrically opposit ...ABS actuator and electric unit (control unit)
Exploded View LHD MR16DDT (2WD), HR16DE 1. ABS actuator and electric unit (control unit) 2. ABS actuator and electric unit (control unit) harness connector 3. Bracket A. To front LH caliper ...Other materials:
P182F coupling temperature sensor left
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.DTC REPRODUCTION PROCEDURE
With ...
HR16DE : Removal and Installation
REMOVAL
1. Disconnect the battery cable from the negative terminal. Refer to PG-124,
"Removal and Installation".
2. Remove radiator reservoir tank. Refer to CO-17, "Exploded View".
3. Disconnect harness connectors (1) from battery terminal with
fusible link.
4. Remove harn ...
Diagnosis system (BCM) (with intelligent key system)
Common item
COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM)
APPLICATION ITEM
CONSULT-III performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE:
It can perform the diagnosis modes except the ...