Nissan Juke Service and Repair Manual : Sensor rotor

Front sensor rotor : Removal and Installation

REMOVAL

Replace wheel hub as an assembly when replacing because sensor rotor cannot be disassembled. Refer to FAX-43, "Removal and Installation".

INSTALLATION

Replace wheel hub as an assembly when replacing because sensor rotor cannot be disassembled. Refer to FAX-43, "Removal and Installation".

Rear sensor rotor : Removal and Installation

REMOVAL

Replace wheel hub as an assembly when replacing because sensor rotor cannot be disassembled. Refer to RAX-5, "Removal and Installation".

INSTALLATION

Replace wheel hub as an assembly when replacing because sensor rotor cannot be disassembled. Refer to RAX-5, "Removal and Installation".

    Wheel sensor
    Front wheel sensor : Exploded View 1. Front LH wheel sensor 2. Front LH wheel sensor harness connector : Vehicle front : N·m (kg-m, in-lb) NOTE: Front RH wheel sensor is symmetrically opposit ...

    ABS actuator and electric unit (control unit)
    Exploded View LHD 1. ABS actuator and electric unit (control unit) 2. ABS actuator and electric unit (control unit) harness connector 3. Bracket A. To master cylinder secondary side B. To m ...

    Other materials:

    Body construction
    Body Construction (RHD Models) 1. Outer side body 2. Outer front pillar reinforcement 3. Upper inner front pillar 4. Lower dash 5. Hoodledge reinforcement 6. Lower front pillar hinge brace 7. Weld nut 8. Side dash 9. Upper hinge plate 10. Lower hinge plate 11. Inner front pillar ...

    Corrosion protection
    Description To provide improved corrosion prevention, the following anti-corrosive measures have been implemented in NISSAN production plants. When repairing or replacing body panels, it is necessary to use the same anti-corrosive measures. ANTI-CORROSIVE PRECOATED STEEL (GALVANNEALED STEE ...

    Rear stabilizer
    Exploded View 1. Stabilizer bar 2. Bushing 3. Stabilizer clamp 4. Stabilizer link 5. Lower link 6. Rear suspension member : Vehicle front : Always replace after every disassembly. : N·m (kg-m, ft-lb) Removal and Installation REMOVAL 1. Remove stabilizer link. 2. Remove center pi ...