Nissan Juke Service and Repair Manual : Security indicator lamp does not turn on or blink
Description
Security indicator lamp does not blink when ignition switch is in a position other than ON.
NOTE
:
• Before performing the diagnosis, check “Work Flow”. Refer to SEC-47, "Work
Flow".
• Check that vehicle is under the condition shown in “CONDITIONS OF VEHICLE (OPERATING CONDITIONS)” before starting diagnosis, and check each symptom.
CONDITIONS OF VEHICLE (OPERATING CONDITIONS)
Power supply position is not the ON position.
Diagnosis Procedure
1.CHECK SECURITY INDICATOR LAMP
Check security indicator lamp.
Refer to SEC-159, "Component Function Check".
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair or replace the malfunctioning parts.
2.CONFIRM THE OPERATION
Confirm the operation again.
Is the result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
NO >> GO TO 1.
Steering does not lock
Description Steering does not lock when door is open while ignition switch is OFF. NOTE: Before performing the diagnosis, check “Work Flow”. Refer to SEC-47, "Work Flow". Diagnosis P ...Vehicle security system cannot BE set
INTELLIGENT KEY INTELLIGENT KEY : Description Armed phase is not activated when door is locked using Intelligent Key. NOTE: Check that vehicle is under the condition shown in “CONDITIONS OF VEHI ...Other materials:
B1148 curtain air bag module
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...
TCM
Exploded View
1. Bracket
2. TCM
:Vehicle front
: N·m (kg-m, in-lb)
Removal and Installation
CAUTION:
When replacing TCM, note the “CVTF DETERIORATION DATE” value displayed on
CONSULT-III “CONFORM
CVTF DETERIORTN” in MAINTENANCE BOOKLET, before start the operation.
NOTE:
When replacing ...
Front drive shaft
Exploded View
LEFT SIDE
1. Circular clip
2. Dust shield
3. Housing assembly
4. Boot band
5. Boot
6. Damper band
7. Dynamic damper
8. Circular clip
9. Joint sub-assembly
: Wheel side
: Fill NISSAN Genuine grease or
equivalent.
: Always replace after every
disassembly.
RIGHT ...