Nissan Juke Service and Repair Manual : Security Control System without intelligent key system
- Precaution
- Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
- Precaution for Procedure without Cowl Top Cover
- Precaution for Battery Service
- System description
- ECU diagnosis information
- Wiring diagram
- Basic inspection
- DTC/circuit diagnosiS
- P1610 lock mode
- P1611 ID discord, IMMU-ECM
- P1612 chain of ECM-IMMU
- P1614 chain of IMMU-KEY
- P1615 diffrence of key
- P1616 ECM
- B2190 nats antenna AMP
- B2191 difference of key
- B2192 ID discord, IMMU-ECM
- B2193 chain of ECM-IMMU
- B2195 anti-scanning
- B2196 dongle unit
- B209f cranking request circuit
- B20A0 cranking request circuit
- B210B starter control relay
- B210C starter control relay
- B210D starter relay
- B210E starter relay
- Hood switch
- Horn function
- Security indicator lamp
- Symptom diagnosis
- Security indicator lamp does not turn on or blink
- Vehicle security system cannot be set
- Vehicle security alarm does not activate
- Removal and installation
Push-button ignition switch
Removal and Installation REMOVAL 1. Remove the NATS antenna amp. Refer to SEC-167, "Removal and Installation". 2. Remove the push-button ignition switch. 1. Disengage the push-button ...Precaution
...Other materials:
P0180 FPT sensor
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.CHECK GROUND CONNECTIONS
1. Turn ignition switch OFF.
2. Check ground connection E38. Refer to Ground inspection in GI-44, "Circuit
Inspection".
Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair or ...
When traveling or registering your vehicle in another country
When planning to travel in another country, you should first find out if the
fuel available is suitable for your vehicle’s engine.
Using fuel with an octane rating that is too low may cause engine damage. All
gasoline vehicles must be operated with unleaded gasoline.
Therefore, avoid taking yo ...
Key warning lamp
Component Function Check
1.CHECK FUNCTION
1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III.
2. Select “INDICATOR” in “ACTIVE TEST” mode.
3. Check that the function operates normally according to the following
conditions.
Is the inspection result normal?
YES >> Key warning lamp ...