Nissan Juke Service and Repair Manual : Secondary speed sensor
Exploded View
1. Transaxle assembly 2. Secondary speed sensor 3. O-ring
: Always replace after every
disassembly.
: N·m (kg-m, in-lb)
: Genuine NISSAN CVT Fluid NS-2
Removal and Installation
REMOVAL
1. Remove air cleaner case. Refer to EM-26, "Removal and Installation".
2. Remove secondary speed sensor connector.
3. Remove secondary speed sensor.
4. Remove O-ring from secondary speed sensor.
INSTALLATION
Note the following, and install in the reverse order of removal.
CAUTION:
• Never reuse O-ring.
• Apply CVT fluid to O-ring.
Inspection and Adjustment
INSPECTION AFTER INSTALLATION
Check for CVT fluid leakage. Refer to TM-480, "Inspection".
ADJUSTMENT AFTER INSTALLATION
Adjust the CVT fluid level. Refer to TM-379, "Adjustment".
Primary speed sensor
Exploded View 1. Transaxle assembly 2. O-ring 3. Primary speed sensor : Always replace after every disassembly. : N·m (kg-m, in-lb) : Genuine NISSAN CVT Fluid NS-2 Removal and Installatio ...Differential side oil seal
Exploded View 1. Transaxle assembly 2. Differential side oil seal (left side) 3. Differential side oil seal (right side) : Always replace after every disassembly. : Genuine NISSAN CVT Fluid ...Other materials:
Line pressure test
Work Procedure
INSPECTION
1. Check the engine oil level. Replenish if necessary. LU-25, "Inspection".
2. Check for leak of the CVT fluid. Refer to TM-480, "Inspection".
3. Drive for about 10 minutes to warm up the vehicle so that the CVT fluid
temperature is 50 to 80°C (122 ...
Component parts
Component Parts Location
LHD MODELS
1. Multi display unit
2. ABS actuator and electric unit (control
unit)
3. A/C auto amp. (With auto air conditioning)
PTC heater control unit (Diesel engine
with manual air conditioning)
4. ECM (Gasoline engine models)
5. IPDM E/R
6. TCM (Gasoline en ...
Front combination lamp
Exploded View
REMOVAL
1. Front combination lamp
: N·m (kg-m, in-lb)
DISASSEMBLY
1. Parking lamp bulb
2. Parking lamp bulb socket
3. Front turn signal lamp bulb socket
4. Front turn signal lamp bulb
5. Front combination lamp housing
Removal and Installation
CAUTION:
Disconnect the ...