Nissan Juke Service and Repair Manual : Seat belt pre-tensioner
Exploded View
Refer to SB-4, "Exploded View".
Removal and Installation
For removal and installation procedures, refer to SB-5, "SEAT BELT RETRACTOR : Removal and Installation".
Diagnosis sensor unit
Exploded View 1. Diagnosis sensor unit : Vehicle front : Do not reuse : N·m (kg-m, ft-lb) Removal and Installation WARNING: • Before servicing, turn ignition switch OFF, disconnect battery ne ...Lap pre-tensioner
Exploded View Refer to SB-4, "Exploded View". Removal and Installation For removal and installation procedures, refer to SB-5, "SEAT BELT RETRACTOR : Removal and Installation" ...Other materials:
Wiring diagram
Engine control system
Wiring Diagram
For connector terminal arrangements, harness layouts, and alphabets in a
(option abbreviation; if not
described in wiring diagram), refer to GI-12, "Connector Information/Explanation
of Option Abbreviation".
...
B2192 ID discord, IMMU-ECM
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON.
2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.
Is DTC detected?
YES >> Go to SEC-60, "Diagnosis Procedure".
NO >> I ...
Key interlock cable
Exploded View
1. CVT shift selector assembly
2. Key interlock cable
A: Key cylinder
B: Clip
C: Clip
Removal and Installation
REMOVAL
CAUTION:
Always apply the parking brake before performing removal and installation.
1. Shift the selector lever to the “P” position.
2. Remove the sele ...