Nissan Juke Owners Manual : Seat belt maintenance

• To clean the seat belt webbing, apply a mild soap solution or any solution recommended for cleaning upholstery or carpets.

Then wipe with a cloth and allow the seat belts to dry in the shade. Do not allow the seat belts to retract until they are completely dry.

• If dirt builds up in the shoulder belt guide of the seat belt anchors, the seat belts may retract slowly. Wipe the shoulder belt guide with a clean, dry cloth.

• Periodically check to see that the seat belt and the metal components, such as buckles, tongues, retractors, flexible wires and anchors, work properly. If loose parts, deterioration, cuts or other damage on the webbing is found, the entire seat belt assembly should be replaced.

    Seat belt extenders
    If, because of body size or driving position, it is not possible to properly fit the lap-shoulder belt and fasten it, an extender that is compatible with the installed seat belts is available that ...

    Child safety
    WARNING Do not allow children to play with the seat belts. Most seating positions are equipped with Automatic Locking Retractor (ALR) mode seat belts. If the seat belt becomes wrapped around a ch ...

    Other materials:

    Clutch pedal position switch
    Component Function Check 1.CHECK FOR CLUTCH PEDAL POSITION SWITCH FUNCTION 1. Turn ignition switch ON. 2. Check the voltage between ECM harness connector and ground. Is the inspection result normal? YES >> INSPECTION END. NO >> Proceed to EC-427, "Diagnosis Procedure" ...

    Door does not lock/unlock with intelligent key
    Diagnosis Procedure 1.CHECK DTC WITH BCM AND TCM Check that DTC is not detected with BCM and TCM. Is the inspection result normal? YES >> GO TO 2. NO-1 >> Refer to BCS-67, "DTC Index". (BCM) NO-2 >> Refer to TM-171, "DTC Index" (RE0F10B models) or TM-3 ...

    P0657 ECM relay
    DTC Logic DTC DETECTION LOGIC NOTE: When IPDM E/R DTC is indicated with DTC P0657, IPDM E/R DTC must be checked first. Diagnosis Procedure 1.CHECK GROUND CONNECTION 1. Turn ignition switch OFF. 2. Check ground connection E38. Refer to Ground Inspection in GI-44, "Circuit Inspection ...