Nissan Juke Owners Manual : Safety — Seats, seat belts and supplemental restraint system
- Seats
- Head restraints/Headrests
- Adjustable head restraint/headrest components
- Non-adjustable head restraint/headrest components
- Remove
- Install
- Adjust
- Front-seat Active Head Restraints
- Seat belts
- Precautions on seat belt usage
- Pregnant women
- Injured persons
- Three-point type seat belt
- Seat belt extenders
- Seat belt maintenance
- Child safety
- Child restraints
- Precautions on child restraints
- Lower Anchors and Tethers for CHildren System (LATCH)
- Rear-facing child restraint installation using LATCH
- Rear-facing child restraint installation using the seat belts
- Forward-facing child restraint installation using LATCH
- Forward-facing child restraint installation using the seat belts
- Installing top tether strap
- Booster seats
- Supplemental restraint system
- Precautions on supplemental restraint system
- NISSAN Advanced Air Bag System (front seats)
- Front seat-mounted side-impact supplemental air bag and roof-mounted curtain side-impact supplemental air bag systems
- Seat belts with pretensioners (front seats)
- Supplemental air bag warning labels
- Supplemental air bag warning light
- Repair and replacement procedure
Warning and indicator lig
: if so equipped ...Seats
WARNING • Do not ride in a moving vehicle when the seatback is reclined. This can be dangerous. The shoulder belt will not be against your body. In an accident, you could be thrown into it and ...Other materials:
B2013 steering lock unit
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Lock the steering.
NOTE:
3. Press the push-button ignition switch.
4. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.
Is DTC detected?
YES >> Go to SEC-69, & ...
P0715 input speed sensor A
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
CAUTION:
Be careful of the driving speed.
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition
switch OFF and wait for at
least 10 seconds, then perform the next test.
> ...
Blower fan on signal
Component Function Check
1.CHECK BLOWER FAN ON SIGNAL
With CONSULT-III
1. Turn ignition switch ON.
2. Select “AIR CONDITIONER” of “BCM” using CONSULT-III.
3. Select “FAN ON SIG” in “DATA MONITOR” mode.
4. Check blower fan ON signal when the fan control dial is operated.
Is the inspection re ...