Nissan Juke Service and Repair Manual : S mode indicator
Component Function Check
1.CHECK S MODE INDICATOR FUNCTION
Check S mode indicator turns ON for approx. 2 seconds when ignition switch turns ON.
Is the inspection results normal? YES >> INSPECTION END
NO >> Go to TM-469, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK DTC (TCM)
With CONSULT-III
1. Turn ignition switch ON.
2. Check “Self Diagnostic Results” in “TRANSMISSION”.
Is any DTC detected? YES >> Check DTC detected item. Refer to TM-366, "DTC Index".
NO >> GO TO 2.
2.CHECK DTC (COMBINATION METER)
With CONSULT-III
Check “Self Diagnostic Results” in “METER/M&A”.
Is any DTC detected? YES >> Check DTC detected item. Refer to MWI-36, "DTC Index".
NO >> GO TO 3.
3.CHECK COMBINATION METER INPUT SIGNAL
With CONSULT-III
1. Shift the selector lever to “D” position.
2. Select “Data Monitor” in “METER/M&A”.
3. Select “O/D OFF IND”.
4. Check that “O/D OFF IND” turns ON/OFF when S mode switch is operated. Refer to MWI-28, "Reference Value".
Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-69, "Removal and Installation".
NO >> GO TO 4.
4.CHECK TCM INPUT/OUTPUT SIGNAL
With CONSULT-III
1. Select “Data Monitor” in “TRANSMISSION”.
2. Select “SPORT MODE SW”.
3. Check that “SPORT MODE SW” turns ON/OFF when S mode switch is operated. Refer to TM-354, "Reference Value".
Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-69, "Removal and Installation".
NO >> Check S mode switch circuit. Refer to TM-466, "Diagnosis Procedure".
S mode switch
Component Function Check 1.CHECK S MODE INDICATOR FUNCTION Check S mode indicator turns ON for approx. 2 seconds when ignition switch turns ON. Is the inspection results normal? YES >> G ...Shift position indicator circuit
Component Parts Function Inspection 1.CHECK SHIFT POSITION INDICATOR 1. Start the engine. 2. Shift selector lever. 3. Check that the selector lever position and the shift position indicator on t ...Other materials:
Unit removal and installation
Transaxle assembly
MR16DDT : Exploded View
1. Transaxle assembly
: Refer to "INSTALLATION" in
TM-84, "MR16DDT : Removal and Installation" for the locations and tightening
torque.
MR16DDT : Removal and Installation
CAUTION:
Never reuse CSC (Concentric Slave Cylinder). ...
Transaxle assembly
Exploded View
CASE AND HOUSING
1. Filler plug
2. Gasket
3. Transaxle case
4. Bushing
5. Snap ring
6. Oil channel
7. Oil gutter
8. Position switch
9. Bracket
10. Differential side oil seal
11. Magnet
12. Drain plug
13. Input shaft oil seal
14. Clutch housing
15. 2 way conn ...
Rear shock absorber
Exploded View
1. Suspension arm
2. Shock absorber
3. Bound bumper
4. Bound bumper cover
5. Washer
6. Bushing
7. Distance tube
8. Piston rod lock nut
9. Cap
: Vehicle front
: Always replace after every
disassembly.
: N·m (kg-m, ft-lb)
Removal and Installation
REMOVAL
1. Remove ...