Nissan Juke Service and Repair Manual : Rocker cover

Exploded View

1. Blow-by hose


1. Blow-by hose
2. Rocker cover
3. Gasket
4. Camshaft position sensor 5. O-ring

A. To turbocharger air inlet pipe

: Always replace after every: N·m (kg-m, in-lb)
disassembly.: Always replace after every
disassembly.

Removal and Installation

REMOVAL

1. Remove air cleaner case. Refer to EM-280, "Exploded View".

2. Remove inlet pipe assembly and air inlet tube. Refer to EM-281, "Exploded View".

3. Remove high pressure protection cover (upper). Refer to EM-294, "Exploded View".

4. Remove electric throttle control actuator.

5. Remove fuel injector. Refer to EM-294, "Exploded View".

6. Remove rocker cover.

• Loosen holding bolts in the reverse order as shown in the figure and remove.

: Engine front


INSTALLATION


INSTALLATION

1. Apply liquid gasket on locations shown in the figure.

• Use Genuine Liquid gasket or equivalent.

2. Tighten holding bolts in the numerical order as shown in the figure.


2. Tighten holding bolts in the numerical order as shown in the figure.

: 12 N·m (1.2 kg-m, 9 ft-lb): Engine front


3. Install in the reverse order of removal after this steps.: 12 N·m (1.2 kg-m, 9 ft-lb)


3. Install in the reverse order of removal after this steps.

Timing belt


    High pressure supply pump
    Exploded View 1. High pressure supply pump protector 2. High pressure supply pump : N·m (kg-m, ft-lb) Removal and Installation REMOVAL CAUTION: • Be sure to read “Precautions for Diesel Equi ...

    Timing belt
    Exploded View 1. Timing belt inner cover 2. Timing belt 3. Camshaft sprocket 4. Timing belt tensioner 5. Timing belt upper cover 6. Timing belt lower cover 7. Cylinder head suspended brac ...

    Other materials:

    Remote keyless entry receiver
    Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “KEYLESS ” or “KEYLESS UNLOCK” in “DATA MONITOR” mode. 3. Check that the function operates normally according to the following conditions. It the inspection result normal? YES >> Rem ...

    Avoiding collision and rollover
    WARNING Failure to operate this vehicle in a safe and prudent manner may result in loss of control or an accident. Be alert and drive defensively at all times. Obey all traffic regulations. Avoid excessive speed, high speed cornering, or sudden steering maneuvers, because these driving pract ...

    Front wiper auto stop signal circuit
    Component Function Check 1.CHECK FRONT WIPER (AUTO STOP) SIGNAL CONSULT-III DATA MONITOR 1. Select “WIP AUTO STOP” of IPDM E/R data monitor item. 2. Operate the front wiper. 3. With the front wiper operation, check the monitor status. Is the status of item normal? YES >> Auto stop sig ...