Nissan Juke Service and Repair Manual : Repairing material
Foam Repair
During factory body assembly, foam insulators are installed in certain body panels and locations around the vehicle. Use the following procedure(s) to replace any factory-installed foam insulators.
URETHANE FOAM APPLICATIONS
Use commercially available Urethane foam for sealant (foam material) repair of material used on vehicle.
<Urethane foam for foaming agent> 3M™ Automix™ Flexible Foam 08463 or equivalent
Read instructions on product for fill procedures.
Example of foaming agent filling operation procedure 1. Fill procedures after installation of service part.
a. Eliminate foam material remaining on vehicle side.
b. Clean area after eliminating form insulator and foam material.
c. Install service part.
d. Insert nozzle into hole near fill area and fill foam material or fill enough to close gap with the service part.
1. Urethane foam
A. Nozzle insert hole
: Vehicle front
2. Fill procedures before installation of service part.
a. Eliminate foam material remaining on vehicle side.
b. Clean area after eliminating foam insulator and foam material.
c. Fill foam material on wheelhouse outer side.
1. Urethane foam
A. Fill while avoiding flange area
Vehicle front
NOTE
:
Fill enough to close gap with service part while avoiding flange
area.
d. Install service part.
NOTE
:
Refer to label for information on working times.
Preparation
...Body component parts
Underbody Component Parts (2WD Models) : Both sided anti-corrosive precoated steel sections : High strength steel (HSS) sections : Both sided anti-corrosive steel and HSS sections NOTE: ...Other materials:
Transaxle assembly
Exploded View
CASE AND HOUSING
1. Differential side oil seal
2. Clutch housing
3. 2 way connector
4. Oil gutter
5. Air breather inner tube
6. Filler plug
7. Gasket
8. Transaxle case
9. O-ring
10. Rear housing
11. Position switch
12. Dowel pin
13. Magnet
14. Drain plug
15. ...
P0603 ECM
Description
ECM has the memory function of the DTC memory, the air-fuel ratio
feedback compensation value memory, the Idle Air Volume Learning
value memory, etc. even when the ignition switch is turned OFF.
DTC Logic
DTC DETECTION LOGIC
*: This self-diagnosis is not for ECM power supply ci ...
P0138 HO2S2
DTC Logic
DTC DETECTION LOGIC
The heated oxygen sensor 2 has a much longer switching time between rich and
lean than the air fuel ratio (A/
F) sensor 1. The oxygen storage capacity of the three way catalyst (manifold)
causes the longer switching
time.
MALFUNCTION A
To judge the malfuncti ...