Nissan Juke Service and Repair Manual : Removal and Installation
REMOVAL
1. Drain engine coolant. Refer to CO-11, "Draining".
CAUTION:
Perform when engine is cold
.
2. Remove front bumper facia. Refer to EXT-12, "Exploded View".
3. Remove charge air cooler. Refer to EM-31, "Exploded View".
4. Remove water haose.
5. Remove oil cooler.
INSTALLATION
Installation is in reverse order of removal.
Exploded View
M/T models 1. Clamp 2. Water hose 3. Oil cooler 4. Water hose N·m (kg-m, in-lb) CVT models 1. Clamp 2. Water hose 3. Oil cooler 4. Water hose 5. Water hose 6. Heater thermostat ...Inspection
INSPECTION AFTER REMOVAL Oil Cooler Check oil cooler for cracks. Check oil cooler for clogging by blowing through engine coolant inlet. If necessary, replace oil cooler assembly. INSPECTION AFTE ...Other materials:
A/C control
Exploded View
1. Intake door cable
2. Mode door cable
3. A/C control
4. Air mix door cable
5. Intake door lever knob
A. To mode door link
B. To intake door link
C. To air mix door link
Removal and Installation
REMOVAL
1. Remove A/C finisher. Refer to IP-13, "Removal and Install ...
Window washer fluid
To fill the window washer fluid reservoir, lift the cap and pour the window washer
fluid into the reservoir opening.
Add a washer solvent to the washer for better cleaning. In the winter season,
add a windshield washer antifreeze. Follow the manufacturer’s instructions for the
mixture ratio ...
Radiator : Inspection
Check radiator for mud or clogging. If necessary, clean radiator as follows.
CAUTION:
• Be careful not to bend or damage radiator fins.
• When radiator is cleaned without removal, remove all surrounding parts such as
radiator cooling fan
assembly and horns. Then tape harness and harness conn ...