Nissan Juke Service and Repair Manual : Removal and installation
- Drive belt idler pulley
- Air cleaner and air duct
- Intake manifold
- Exhaust manifold
- Oil pan (lower)
- Fuel injector and fuel tube
- Ignition coil, spark plug and rocker cover
- Timing chain
- Camshaft
- Oil seal
- Cylinder head
Spark plug
Removal and Installation REMOVAL 1. Remove ignition coil. Refer to EM-178, "Exploded View". 2. Remove spark plug with a spark plug wrench (commercial service tool). a : 14 mm (0.55 in) ...Drive belt idler pulley
Removal and Installation REMOVAL 1. Remove drive belt. Refer to EM-155, "Removal and Installation". 2. Remove the lock nut, and then remove the plate (7), idler pulley (6), and washer (5 ...Other materials:
Hazard switch
Component Function Check
1.CHECK HAZARD SWITCH SIGNAL BY CONSULT-III
CONSULT-III DATA MONITOR
1. Turn the ignition switch ON.
2. Select “HAZARD SW” of BCM (FLASHER) data monitor item.
3. With operating the hazard switch, check the monitor status.
Is the inspection result normal?
YES >> ...
P1551, P1552 battery current sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following before conducting
the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. ...
System (power door lock system)
System Diagram
System Description
DOOR LOCK FUNCTION
Door Lock and Unlock Switch
• The door lock and unlock switch (driver side) is build into power window main
switch.
• The door lock and unlock switch (passenger side) is build into front power
window switch (passenger side).
• Interloc ...