Nissan Juke Service and Repair Manual : Removal and installation
- Navi control unit
- Front door speaker
- Tweeter
- Rear door speaker
- Antenna base
- GPS antenna
- Microphone
- Steering switch
- Rear view camera
- USB connector and AUX jack
- Antenna feeder
Normal operating condition
Description NOTE: For Navigation system operation information, refer to Navigation system Owner's Manual. BASIC OPERATIONS NOTE: Locations stored in the Address Book and other memory functi ...Navi control unit
Removal and Installation REMOVAL 1. Remove cluster lid C. Refer to IP-12, "Exploded View". 2. Remove NAVI control unit screws. 3. Disconnect NAVI control unit connectors to remove NAVI c ...Other materials:
Diagnosis system (IPDM E/R)
Diagnosis Description
AUTO ACTIVE TEST
Description
In auto active test mode, the IPDM E/R sends a drive signal to the following
systems to check their operation.
• Oil pressure warning lamp (only for K9K engine models)
• Rear window defogger
• Front wiper motor
• Parking lamp
• License p ...
BCM
Removal and Installation
CAUTION:
Before replacing BCM, perform “READ CONFIGURATION” to save or print current
vehicle specification.
Refer to BCS-80, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM) :
Description".
REMOVAL (RHD MODELS)
1. Remove glove box assembly. Refer to I ...
U1001 Can comm circuit
Description
CAN (Controller Area Network) is a serial communication line for real time
application. It is an on-vehicle multiplex
communication line with high data communication speed and excellent error
detection ability. Many electronic
control units are equipped onto a vehicle, and each c ...