Nissan Juke Service and Repair Manual : Removal and installation
PUSH-BUTTON IGNITION SWITCH
Removal and Installation
REMOVAL
1. Remove the NATS antenna amp. Refer to SEC-167, "Removal and Installation".
2. Remove the push-button ignition switch.
1. Disengage the push-button ignition switch fixing pawls using minus driver etc.
2. Press the push-button ignition switch to remove it from cluster lid A (2).
: Pawl
INSTALLATION
Install in the reverse order of removal.
Push-button ignition switch position indicator does not illuminate
Description • Before performing the diagnosis in the following table, check “Work Flow”. Refer to PCS-88, "Work Flow". • Check that vehicle is under the condition shown in “Conditions of ...Charging System
...Other materials:
Oil cooler
Exploded View
1. Cylinder block
2. Water pipe
3. O-ring
4. O-ring
5. O-ring
6. Oil cooler
7. Connecting stud
8. O-ring
9. Oil filter bracket
10. Oil pressure switch
11. Oil filter
12. O-ring
13. Connecting bolt
A. : To radiator lower hose
B. : To water pump
: N·m (kg-m, ft- ...
Operation
AUTOMATIC SPEED CONTROL DEVICE (ASCD)
AUTOMATIC SPEED CONTROL DEVICE (ASCD) : Switch Name and Function
SWITCHES AND INDICATORS
1. CRUISE indicator
2. SET indicator
3. CANCEL switch
4. RES / + switch
5. SET / − switch
6. Speed limiter MAIN Switch
7. ASCD MAIN switch
A. On the co ...
Door lock and unlock switch
Driver side
DRIVER SIDE : Component Function Check
1.CHECK FUNCTION
1. Select “DOOR LOCK” of “BCM” using CONSULT-III.
2. Select “CDL LOCK SW”, “CDL UNLOCK SW” in “DATA MONITOR” mode.
3. Check that the function operates normally according to the following
conditions.
Is the inspection resul ...