Nissan Juke Service and Repair Manual : Removal and installation

Nissan Juke Service and Repair Manual / Horn / Removal and installation

HORN

Exploded View

WITHOUT VEHICLE SECURITY SYSTEM

1. Horn high


1. Horn high
2. Horn low
3. Horn bracket

WITH VEHICLE SECURITY SYSTEM

1. Horn low


1. Horn low
2. Horn bracket

Removal and Installation

REMOVAL

Without Vehicle Security System 1. Remove the front center grille and front side grille (LH/RH). Refer to EXT-18, "Removal and Installation".

2. Disconnect the horn (high and low) connectors.

3. Remove the horn mounting bolts (A). Remove the horn high (1) and horn low (2).

4. Remove harness fixing clip from horn bracket.

: Harness fixing clip


5. Remove horn bracket mounting bolts (LH/RH). Remove horn


5. Remove horn bracket mounting bolts (LH/RH). Remove horn bracket (1) from radiator core support upper.

With Vehicle Security System


With Vehicle Security System 1. Remove the front center grille and front side grille (LH/RH). Refer to EXT-18, "Removal and Installation".

2. Disconnect the horn low connectors.

3. Remove the horn mounting bolt (A). Remove the horn low (1).

4. Remove harness fixing clip from horn bracket.

: Harness fixing clip


5. Remove horn bracket mounting bolts (LH/RH). Remove horn


5. Remove horn bracket mounting bolts (LH/RH). Remove horn bracket (1) from radiator core support upper.

INSTALLATION


INSTALLATION

Install in the reverse order of removal.

    Wiring diagram
    HORN Wiring Diagram For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, "Connector Information/ ...

    Other materials:

    Fuel injector and fuel tube
    Exploded View 1. Stud bolt 2. O-ring (green) 3. Fuel injector (front) 4. Clip 5. Fuel injector (rear) 6. O-ring (black) 7. Fuel tube protector 8. Fuel tube 9. Fuel feed hose 10. Quick connector cap A. To centralized under-floor piping : Always replace after every disassembly. ...

    Brake pedal position switch
    Component Function Check 1.CHECK BRAKE PEDAL POSITION SWITCH FUNCTION With CONSULT-III 1. Turn ignition switch ON. 2. Select “BRAKE SW1” in “DATA MONITOR” mode of “ENGINE” using CONSULT-III. 3. Check “BRAKE SW1” indication as per the following conditions. Without CONSULT-III 1. Turn ignitio ...

    Rear window defogger on signal
    With auto A/C WITH AUTO A/C : Description Turns the indicator lamp in the rear window defogger switch ON when operating the rear window defogger WITH AUTO A/C : Component Function Check 1.CHECK REAR WINDOW DEFOGGER ON SIGNAL Check that the indicator lamp of rear window defogger switch is illu ...