Nissan Juke Service and Repair Manual : Removal and installation
- Headlamp
- Front combination lamp
- Front fog lamp
- Light & rain sensor
- Lighting & turn signal switch
- Hazard switch
- Side turn signal lamp
- Headlamp aiming switch
- Rear combination lamp
- High-mounted stop lamp
- License plate lamp
- Rear fog lamp
Front fog lamp aiming adjustment
Description PREPARATION BEFORE ADJUSTING NOTE: For details, refer to the regulations in your own country. Before performing aiming adjustment, check the following. • Adjust the tire pressure ...Headlamp
Exploded View REMOVAL 1. Headlamp assembly 2. EPT sealer [2.8 mm (0.110 in)] : Do not reuse : N·m (kg-m, in-lb) DISASSEMBLY 1. Back cover 2. Halogen bulb 3. Headlamp housing assembly ...Other materials:
Engine protection control at low engine oil pressure
Engine protection control at low engine oil pressure : System Diagram
Engine protection control at low engine oil pressure : System Description
INPUT/OUTPUT SIGNAL CHART
SYSTEM DESCRIPTION
• The engine protection control at low engine oil pressure warns the driver
of a decrease in engine ...
P1220 fuel pump control module
(FPCM)
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
• Before performing the following procedure, confi ...
Brake fluid level switch
Component Function Check
1.CHECK BRAKE FLUID LEVEL SWITCH OPERATION
When the brake fluid is full or empty. Then check that the brake warning lamp
in the combination meter turns
ON/OFF correctly.
Is the inspection result normal?
YES >> INSPECTION END
NO >> Proceed to BRC-72, &qu ...