Nissan Juke Service and Repair Manual : Removal and installation
POWER WINDOW MAIN SWITCH
Removal and Installation
REMOVAL
1. Remove power window main switch finisher. Refer to INT-13, "Removal and Installation".
2. Remove power window main switch (1) from power window main switch finisher (2) using flat-head screw driver (A).
: Pawl
CAUTION:
Do not fold the pawl of power window main switch finisher.
NOTE:
The same procedure is also performed for front power window switch (passenger side) and rear power window switch (LH & RH).
INSTALLATION
Install in the reverse order of removal.
NOTE
:
If power window main switch is replaced or is removed, it is necessary to
perform the initialization procedure.
Refer to PWC-16, "Work Procedure".
Power window lock switch does not function
Diagnosis Procedure 1.REPLACE POWER WINDOW MAIN SWITCH Replace power window main switch. >> Refer to PWC-44, "Removal and Installation". ...Body Repair
...Other materials:
Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE:
• Before removing and installing any control units, first turn the ignition
switch to the LOCK position, then disconnect
both battery cables.
• After finishing work, confirm that all control unit connectors are connected
properly, then re-connect both
battery cables.
• Always use CONS ...
B26EF steering lock relay
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B26EF is displayed with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to
BCS-83, "DTC Logic".
• If DTC B26EF is displayed with DTC U1010, first perform the trouble diagnosis
for DTC U1010. Refer to
BCS-84, "D ...
System initialization
Description
If any of the following operations are performed, the initialization is
necessary for normal operation of power
window system.
• Disconnection and connection of battery cable from negative terminal.
• When power window main switch replaced.
• Electric power supply to power windo ...