Nissan Juke Service and Repair Manual : Removal and installation
- Front door finisher
- Rear door finisher
- Body side trim
- Floor trim
- Headlining
- Luggage floor trim
- Back door trim
Symptom diagnosis
Squeak and rattle trouble diagnoses Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet ...Front door finisher
Exploded View LHD models 1. Front door panel 2. Front door finisher 3. Cap 4. Pull handle 5. Power window switch finisher 6. Pull handle bracket : Clip : Pawl : Metal clip Removal and ...Other materials:
P1701 TCM
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition
switch OFF and wait for at
least 10 seconds, then perform the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
1. S ...
The ambient temperature display is incorrect
Description
• The displayed ambient air temperature is higher than the actual
temperature.
• The displayed ambient air temperature is lower than the actual temperature.
Diagnosis Procedure
NOTE:
Check that the symptom is not applicable to the normal operating condition
before starting diagn ...
Blower fan on signal
Component Function Check
1.CHECK BLOWER FAN ON SIGNAL
With CONSULT-III
1. Turn ignition switch ON.
2. Select “AIR CONDITIONER” of “BCM” using CONSULT-III.
3. Select “FAN ON SIG” in “DATA MONITOR” mode.
4. Check blower fan ON signal when the fan switch is operated.
Is the inspection result n ...