Nissan Juke Service and Repair Manual : Removal and installation
- Controller
- A/C auto AMP.
- Ambient sensor
- In-vehicle sensor
- Sunload sensor
- Intake sensor
- Refrigerant pressure sensor
- Power transistor
- Door motor
Compressor dose dot operate
Description SYMPTOM Compressor dose not operate. Diagnosis Procedure NOTE: • Perform self-diagnoses with CONSULT-III before performing symptom diagnosis. If any DTC is detected, perform the co ...Controller
Removal and Installation REMOVAL Remove multi display unit. Refer to IP-13, "Removal and Installation". INSTALLATION Install in the reverse order of removal. ...Other materials:
Diagnosis system (ECM)
Diagnosis description
Diagnosis description : 1st Trip Detection
Logic and Two Trip Detection Logic
When a malfunction is detected for the first time, 1st trip DTC and 1st trip
Freeze Frame data are stored in the
ECM memory. The MIL will not illuminate at this stage. <1st trip>
If the s ...
C1143 steering angle sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
With CONSULT ...
Compressor dose dot operate
Description
SYMPTOM
Compressor dose not operate.
Diagnosis Procedure
NOTE:
• Perform self-diagnosis with CONSULT-III before performing symptom diagnosis.
If any malfunction result or
DTC is detected, perform the corresponding diagnosis.
• Check that refrigerant is enclosed in cooler cycle n ...