Nissan Juke Service and Repair Manual : Removal and installation
Rear disc brake
Brake pad : Inspection and Adjustment INSPECTION Check brake pad wear thickness from an inspection hole on cylinder body. Check using a scale if necessary. Wear thickness : Refer to BR-71, "R ...Brake pedal
Exploded View WITHOUT ESP 1. Clevis pin 2. Brake pedal assembly 3. Brake pedal pad 4. Stop lamp switch 5. Clip 6. Snap pin : Apply multi-purpose grease. : N·m (kg-m, ft-lb) WITH ESP ...Other materials:
Component parts
Component Part Location
1. BCM
Refer to BCS-161, "Removal and Installation".
2. Heater control
3. Blower fan resistor
4. Blower motor
A. Left side of heater unit assembly
B. Right side of heater unit assembly
Component Description
Heater and ventilation unit assembly : Blowe ...
B2098 ignition relay on stuck
Description
The ignition relay integrated in IPDM E/R is operated with ignition switch ON
signal from the ignition switch.
DTC Logic
DTC DETECTION LOGIC
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON.
2. Check DTC in “Self Diagnostic Result” mode of “IPDM E/R” using CONSUL ...
C1101, C1102, C1103, C1104 wheel sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
With CONSULT ...