Nissan Juke Service and Repair Manual : Removal and installation
Rear drive shaft
Inspection • Check drive shaft mounting point and joint for looseness and other damage. • Check boot for cracks and other damage. CAUTION: Replace entire drive shaft assembly when noise or vib ...Rear wheel hub and housing
Exploded View 1. Axle housing 2. Suspension arm 3. Back plate 4. Hub bolt 5. Wheel hub assembly (Bearing-integrated type) 6. Disc rotor 7. Plug 8. Wheel hub lock nut 9. Cotter pin : ...Other materials:
Brake piping
Front : Exploded View
WITHOUT ESP
1. Brake tube
2. ABS actuator and electric unit (control
unit)
3. Connector
4. Connector bracket
5. Master cylinder assembly
6. Brake booster
7. Lock plate
8. Brake hose
9. Union bolt
10. Copper washer
A. To rear brake tube
: N·m (kg-m, ft-lb)
...
Engine idle speed too low or unstable
Description
CHART 6: ENGINE IDLE SPEED TOO LOW OR UNSTABLE
Diagnosis Procedure
1.CHECK FUEL
Check that the fuel reservoir is correctly filled and with the right fuel.
>> GO TO 2.
2.CHECK ECM POWER SUPPLY AND GROUND CIRCUIT
Check ECM power supply and ground circuit. Refer to EC-885, ...
Map light control switch (if so equipped)
The map lights control switch has three positions: ON1 , OFF2 and center.
ON position
When the switch is in the ON position 1 , the map lights will illuminate.
OFF position
When the switch is in the OFF position2 , the map lights will not illuminate,
regardless of the condition.
Center posi ...