Nissan Juke Service and Repair Manual : Removal and installation
- CVT shift selector
- Control cable
- Key interlock cable
- TCM
- Air breather hose
- G sensor
- Oil pan
- Primary speed sensor
- Secondary speed sensor
- Output speed sensor
- Differential side oil seal
- Water hose
- Fluid cooler system
- Plug
Periodic maintenance
CVT FLUID Inspection FLUID LEAKAGE • Check transaxle surrounding area (oil seal and plug etc.)for fluid leakage. • If anything is found, repair or replace damaged parts and adjust CVT fluid leve ...CVT shift selector
Exploded View 1. Selector lever knob 2. Lock pin 3. Knob cover 4 Position indication panel 5. CVT shift selector assembly 6. CVT shift selector harness assembly 7. Detent switch* 8. Shi ...Other materials:
System
Charging system
CHARGING SYSTEM : System Diagram
GASOLINE ENGINE MODELS
DIESEL ENGINE MODELS
CHARGING SYSTEM : System Description
The alternator provides DC voltage to operate the vehicle's electrical system
and to keep the battery charged.
The voltage output is controlled by the IC vo ...
B1066, B1071 passenger air bag module
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...
Cooling fan
Exploded View
1. Fan motor
2. Fan shroud
3. Cooling fan
A. Apply on fan motor shaft
: N·m (kg-m, in-lb)
: Apply genuine high strength thread
locking sealant or equivalent.
Removal and Installation
REMOVAL
1. Drain engine coolant. Refer to CO-11, "Draining".
CAUTION:
• Pe ...